RideFixerGeneric displays error code
Generic displays error E02: Brake applied
Low severity When convenient
Can I ride home with this error?
Usually safe to ride. Safe to ride if the brakes work normally.
What it means
The brake cut-off switch is telling the controller to stop the motor. This is normal while braking. If it stays on, a brake lever or its sensor may be stuck. On generic displays the meaning of a code depends on the controller's communication protocol; this meaning is from the display maker's manual for this protocol.
Likely causes
- Brake lever pulled
- Lever not springing back
- Brake sensor or connector fault
Symptoms
- E02 shows
- No assist or throttle
How to fix it
- Let go of both brake levers.
- Check each lever springs back fully.
- Check the brake sensor connectors are pushed fully in.
- Switch the bike off, wait 10 seconds and switch it on again.
- If the code stays, take the bike to your dealer or an e-bike repair shop.
How urgent is it?
Only act if it stays on with the levers released.
Applies to
Did this help?